This workshop repair kit contains 64 high quality O-rings to replace all the flow and fill valve seals in 8 Tokyo Marui, KSC/KWA & WE green gas pistol magazines, all supplied in a high quality compartment box.

Unlike cheap kits for plumbing and DIY which often contain lower quality O-rings in sizes that are too large this kit only contains sizes which have been tried and tested in airsoft magazines by LPE, these kits are ideal for airsoft sites and techs offering a magazine repair service or players who own a range of gas guns which may start to leak the night before a skirmish!

This kit can be used to replace all the release and fill valve seals in up-to 8 Tokyo Marui pistol magazines, up-to 6 WE pistol magazines, up-to 4 KSC/KWA pistol magazines or a mix of the three to a maximum of 8 magazines. If only leaking O-rings are replaced this kit could be used to repair many more magazines.

Confirmed to fit the following Tokyo Marui gas pistol magazines :-

P226
Hi-Capa
M1911A1
MEU
Detonics .45 Combat Master
5-7
G-Series
XDM-40
Mk23 SOCOM fixed slide
Hk45
Px4
MP7

It is very likely this kit will also fit other Tokyo Marui gas pistol magazines and direct clones of them but this kit has not been tested and confirmed to fit if not listed.

This kit is not suitable for the Tokyo Marui M4 MWS GBBr magazines or tri-shot gas tanks.

Confirmed to fit the following KSC/KWA gas pistol magazines :-

USP Series
G Series
Cz75
P226
M9
M93r
STI Tactical
M11
MP9
MP7

This kit is not suitable for the KSC/KWA KRISS Vector or LM4/M4 magazines.

Confirmed to fit the following WE gas pistol magazines :-

M1911
MEU
Hi-Capa
P226
P228
M9
XDM
Px4
M&P
TT33
G-Series
G39 GBBr
M14 GBBr

This kit is not suitable for the WE Browning High Power or Luger magazines.


Assembled in the United Kingdom by Lees Precision Engineering.